Flatten round hole bottoms with ease!
A spinning chisel tool that has never existed before.
Excellent for use as a thin-blade chisel tool.
Installed on a pin vice body for flat processing of drill hole bottoms and use as a small chisel tool.
The shaft is standardized to 3mm, eliminating the need to replace the collet chuck of pin vises, resulting in easy replacement.
*Please take extra caution when handling the blades, especially when opening the storage case or during use.
▼How to use
1. Attach a drill blade to a pin vise to drill a hole.
2. Attach a spin blade with the same diameter as the drilled hole to the pin vise.
3. Flatten the bottom of the drilled hole with the spin blade.
Flattening the bottom surface of a hole made with a drill blade of the same diameter (drilling edge processing) is possible.
Standardized to shaft size 3mm
Spin Blade single item specifications in 0.1 mm increments between 1.1 mm and 2.9 mm other than 5pcs set
Excellent for use as a thin-blade chisel tool.
Spin Blade 2.9mm
■Product Code：GH-SB-2.9
●Quality Indication
・Material: Special cutlery steel (with case)
・Hole diameter: 2.9 mm
・Case: PP
・Shaft thickness: 3 mm
・Made in Japan
⚠NOTE
・Please fix the pin vise firmly in place before use.
・Please be sure no one is around and wear protective glasses.
Cutting materials or broken blades in the eyes may cause blindness.
・Blades made of hard metal, however, may damage or injure unexpectedly if excessive force is applied or improperly used.
・After use, wipe with a dry cloth, lubricate with oil, and place in the case.
・Please be careful to avoid injury
・Please do not apply a load exceeding the capacity.
・When spinning the Spin Blade, ensure to drill pilot holes with the same diameter before use.
